Hi all,I've setup Wireguard on my Vigor 2927 router at home (my network is VLAN'ed as well)The issue is that, when WireGuard is enabled on a device already on the target LAN I can't resolve anything at all  - local hostnames, or the Internet.I'm no expert but from what I've read about, I'm leaning towards Hairpin or Loopback NAT but I really don't know how I go about configuring this correctly on the Vigor 2927.

Wireguard is using interface LAN1 - 192.168.0.1/24

Remote access works fine, I can tunnel back into my home network (I only have a full tunnell setup right now)

Can anyone help with this?