DrayTek UK Users' Community Forum
Help, Advice and Solutions from DrayTek Users
Mesh config sync never fully finishes
- mcdope
- Topic Author
- Offline
- New Member
-
04 May 2025 11:30 #104896
by mcdope
Mesh config sync never fully finishes was created by mcdope
Hi,
I've got an interesting but mildly annoying problem with my Mesh setup. It refuses to ever finish the settings sync. The indicator in the routers Mesh Status page stays yellow and only the primary SSID is transferred to the APs.
Router: 2865Lac with FW 4.4.6.1_STD
Nodes: 2x 903 with FW 1.4.18 (both connected via wired uplink on LAN-A1)
As a workaround I just manually configured the remaining AP-Settings. But obviously I would like to have a working config sync from the router
Have I missed some setting? Or am I just expecting too much from the config sync and that's intended behavior?
I've got an interesting but mildly annoying problem with my Mesh setup. It refuses to ever finish the settings sync. The indicator in the routers Mesh Status page stays yellow and only the primary SSID is transferred to the APs.
Router: 2865Lac with FW 4.4.6.1_STD
Nodes: 2x 903 with FW 1.4.18 (both connected via wired uplink on LAN-A1)
As a workaround I just manually configured the remaining AP-Settings. But obviously I would like to have a working config sync from the router
Have I missed some setting? Or am I just expecting too much from the config sync and that's intended behavior?
Please Log in or Create an account to join the conversation.
Moderators: Chris